Quote:
|
Originally Posted by 88ReX
my best word of advice, because i've done this before, is make sure you fish it through with the old speedo cable because otherwise its a bitch to get it through all the stuff behind the dash
|
Yea, tape/tie the old one to the new one to pull it through the firewall. Other than that its easy, take the cluster off a few screws under it and a few on the top back side facing the windshield(you need a stubby screw driver)under little plastic clips. Should take you.....30mins at most. As far as a knock sensor, if its a stock crx engine you have no knock sensor. If you have a newer swap its on the backside of the engine near/above the oil filter usually.
__________________
B18 with a B16 head
70mm throttle body-Skunk2 Intake Manifold
1000cc Injectors-Eagle rods-CP 9:1 pistons
ACT 12lb flywheel-ACT 6 puck sprung clutch
Quaife LSD-Full Race Traction Bar
Full Race t3/60-1 turbo kit-Ram Horn Manifold
205/60/14 BF Drag Radials
331HP at 14psi
Currently for sale 
|
