Thread: rebuilding !!!!!!
View Single Post
Old 10-22-2007, 11:32 PM   #1 (permalink)
hidiouskinky
Noob
 
hidiouskinky's Avatar
 
Join Date: Dec 2006
Location: HAMMOND, LA
Posts: 57
Car: 99ek-slightly built gsr
Mods: gsr...aem;tru time cam gears, hybrid cold air intake...LSD trans...ACT;8lb. flywheel, stage 3-6 puck clutch...greddy sp2 full exhaust with test pipe...rare SI power steering...CTR crank pulley...even rarer enkei J SPEED3 wheels with dunlop super sport 901 rubber an ingals motor damper, OBDI conversion, SKUNK2 valve train
hidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhilehidiouskinky Needs to go outside once in awhile
rebuilding !!!!!!
ok guys....i have spun a bearing and i have decided to rebuild the bottom end....my head has been equiped with skunk2 pro series valve train....im going to b boosting in about a yr....i know i have to do some honing and what-not to the block....im adding race bearings to the mix....im pretty much doing what i can except adding lower CP....can anyone out there give me any advise as to what size i need to hone the bottom end out to....any help would b GREATLY appreciated
__________________
99EK..ACT STAGE3 6PUCK CLUTCH AND 8LB FLYWHEEL..AEM CUSTOM CAI AND 5 BOLT TRU TIME CAM GEARS..GREDDY SP2 CATBACK EXHAUST..SKUNK2 VALVE TRAIN..QUAIFFE LSD..ENKEI J SPEED3 WHEELS WITH DUNLOP SP 901 RUBBER..2000 SI POWER STEERING PUMP..INGALS ENGINE DAMPER..BLOCK BORED .20 OVER..JUST ADDED EAGLE CRANK, H-BEAM RODS..SRP PISTONS..ACL BEARINGS..ARP HEAD STUDS
hidiouskinky is offline   Reply With Quote
Sponsored Links
Advertisement