Thread: 70 mm throttle body and 3" exhaust
View Single Post
Old 03-13-2008, 07:11 PM   #5 (permalink)
jarrod_aspden
SuperHonda Member
 
jarrod_aspden's Avatar
 
Join Date: Jan 2007
Location: Arlington WA
Posts: 104
Car: 2001 s2000 - 1995 Prelude si
Mods: s2000 FIPK K&N air intake, NGK iridiums, custom oil catch tank, custom radiator cooling plate and tsw tracklites. - 1995 Prlude si fuckin thieves!!!
jarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these partsjarrod_aspden is infamous around these parts
Quote:
Originally Posted by Ap1_S2k View Post
Why would you buy the Spoon ECu then get a tune???

Then Spoon ECU is very expensive but is also very nice for lightly modded NA cars. If I were you I would not go past a 70mm exhaust and I would get some type of piggyback EMU and tune it.


You talkin like a apexi fuel controller ? This is where I kinda get lost I thought you would get all the parts installed then get it tuned on a dyno right or am I just retarted?

P.S. Not trying to be a dick or anything but I was talkin about a 70 mm throttle body and a 3" exhaust. Also

Thnx for the input though
__________________
I gotta AP1!!!



I'm a welder
jarrod_aspden is offline   Reply With Quote