My setup is a b18c JR . Now my questions is, if i pull out the pcv valve and replace it with a elbow and some hose routing down, can i just block of the nipple on the neck of the blower? I'm not looking to spend any money on a catch can so i'm just going to route the hoses down from the pcv valve and the valve cover.
I've read articles where venting the block is easier on the rings etc. also helps prevent detonation. Here is where i was reading it, its somewhat similiar to all b-series motors that are boosted.
http://www.beesandgoats.com/boostfaq/g2icturbo.html#PCV
To u guys not using a catch can how do u have this setup?
Linear Mode
