Need help with a N/A D-series setup

[sweetrex]

I want to build a N/A d16z6 to put down at least 160 to 200 whp. so far I have the head and intake manifold port and polish. I need some advice on what head components I could use to make a nice set up. My plan was to put skunk2 camshaft and gear. also what can I do with the block besides changing the pistons.

[ek9wannabe]

good luck, i hope u can acheive that, but it seems to me to be a lttle out of reach without a turbo on a dseries

[Gr3nd3l]

It can be done but it wont be streetable.

[Sirfallsalot243]

Id lower your goal. I think 160 is doable. To make 200 youll need a MONSTER cam and like a 12:1 compression ratio. Good luck daily driving it.

[Gr3nd3l]

160 could be done but it would have to built and a really good tune

[flyingtoaster]

12.7:1 c/r y7 motor is DONE!! lOOk!! See!!

I don't think there are any HP numbers, but he was using race gas. It's not practical, in my opinion.

[Gr3nd3l]

i wouldnt go higher than 11:5 compression on a street d16. I have seen people run 12 but they had really really good tunes.