|
engine problem
i just bought a engine off of someone for my 91 crx hf. the motor is a 90 si motor and i just swapped it in using all of my hf parts such as tranny wiring harness, ecu, distributer, fuel injector...etc... when i went to start the car after i swapped it in, it did not start, it almost turns over but doesnt. i checked the compression on all 4 cylinders and the first three were 125 and the last was around 30. is there any way to fix this problem any suggestions or anything would help....i could get a different si motor but it would be a huge pain to go through the swap again b/c i have to rent out garage and if anyone in the central jersey area wants to come look at it to give me advise let me know. thanks a lot in advanced.
later
|
Linear Mode
