Mold Stock rear bumper???

[Phre0nBurn]

Hey, How hard do you think It would be to mold the stock rear bumper to the car, then mold in the little cutout for the exhaust so it looks like it was never there??
or, should i just go with a WW kit...??
Any good bumpers out there? I want something that doesnt look too plain, but then again, i want something that doesnt look like im trying to fly away...

[Phre0nBurn]

oh, also, whattya guys think about this... trying to figure out my master plan....
Fiberglass single peice front end 3" wider than stock, with cutouts for the lights , WW Molded side skirts, Stock rear bumper, molded w/ the exhaust cutout molded...
I just wish the stock rear bumper was a little bit lower....
Anyways, No lower outside panels on the doors, with the little trim that goes all around the car shaved... not filled in, but just the holes shaved, and the holes at the bottom of the doors where the panel went shaved, shaved antenna hole and water gutters on the roof, maybe shave the sunroof panel hole ( damn sunroof refuses to open and close right )
Just want your thoughts on this, criticism is cool, just be honest...
oh, the entire car will be black w/ black rims, tinted windows
thanks
peace