B20 swap questions

[671]

Ok I'm dead set on putting in the B20 but I still need have some questions

1. Will I need new motor mounts
2. Will any B-series Auto trans bolt to the B20
3. How much$$ to resleeve the block and who does them(Preferably some where in AZ)
4. What ECU should I use.

Thanks Zach

[lump]

1. what car is it going in?
2. Please get a standard, auto's are fer pussies
3. A lot of $$$$ the sleeve's aren't sleeve's it's one giant sleeve. And im sure theres some people in AZ who can do it, Golden Eagle does it. But you have to ship them the block.
4. B16ecu or an Integra one. DOHC VTEC ecu.

[671]

It's going into a 98 Civic

[90Si]

mounts yes ( you need axles and shift linkage to..)
any Bseries tranny will bolt up. but an auto tranny is stupid, just get an LS, if your goin for turbo
B20 is NOT by all means a high revving motor, so be careful

[671]

Well the B20 will have new pistons rods and a stock crank and will be resleeved and I don't plan on revving past 8200rpm is that still too high for a built motor.