JDM EJ conversion

[christ.deyoung]

Well, I'm expecting my JDM B18C on thursday or friday. Comes complete with engine harness and p72 ECU. It is an OBD1 motor, and is going to be put into my OBD2b 2000 Civic SE this winter. My question is, what am I going to need for electrical components to make this motor run? I understand I am going to need to convert to OBD1 (I'm going to pick up a rywire jumper harness), I'll need to wire the vtec, and the IAB (whatever that is). Sorry for the noobish question, but I can't seem to find much information on this swap. Thanks in advance for your help fella's.

[eKaLLmOtOr97]

Check this link out. 6th gen Civic B-series swap info

[hondastreet]

use your harness to converted your system and use your swap engine harness B18C, plug and play

[JDMB18C5_EG]

From OBDI -> OBDII you're going to need a couple of extra O2 sensors.

[christ.deyoung]

Well, the motor was wired up by myself, and plopped into the car months ago. I didn't get a chance to run it on the road yet, because I'm just finishing the turbo installation. Hopefully everything will run properly when it hits the road in a couple weeks.