OK guys, This is my problem. I bought a turbo 98 ex from a guy and for the most part what he said the car was it was but there is a big problem. it dropped a rod bearing into the oil pan while we where pulling the car off the trailer(yea that really sucks) in any case I have a d16y5 from a few years back sitting in my garage. My question is can i Just take my head from my new motor and the bottom end of the other and run with that until I get my bottom end all patched up... I have searched and searched on this topic but i cannot find a clear answer links or comments are welcomed. thanks guys josh
__________________
N/A is Best
Honda= <3
Going fast in corners is funner than going straight
Last edited by VwtoHonda : 08-13-2007 at 02:10 PM.
Reason: spelling
Mods: H&R sports, koni yellows, enkei 15's, y8 IM, apexi N1 catback, redded out tails, black housing heads, DIY front grill, all moldings painted, DcSport short shifter, type-r shift knob, makeshift AEM SRI, rear si sway bar, cross/slotted front rotors
you mean the bottom end from the y5 and put that on the y8? if so, yeah that will work.
Yeah, You can run that without a problem, the only thing I could see is it being a mini me like that, you might not get as much power if it increases your compression ratio. But it'll run.
Yeah, You can run that without a problem, the only thing I could see is it being a mini me like that, you might not get as much power if it increases your compression ratio. But it'll run.
they are IDENTICAL blocks y8/y7/y5
__________________ MY VOUCHERS: -Paypal:danijel_danicic@hotmail.com -Ebay:dado03235
AutoForums.com is the premier network of enthusiast-owned
enthusiast-operated automotive communities.
We operate more than 100 automotive forums where our users consult peers for shopping information and advice, and share
experiences and opinions as a community.
Linear Mode
