Car won't start

[Tulo]

I have the rev hard turbo kit on my 01 GSR. I installed 550cc injectors and am running -48% - -42% on my VAFC. I probably should have taken my vortech FMU and missing link off before the test run, but I didn't. It started right up and ran fine, so I went into boost in first through third a couple times, then the car just died after the last run. I have not been able to start it since. I have since taken the FMU off, but it still will not start. I'm thinking that it had to of been running insanely rich, and maybe the engine is flooded? I don't know much about this sort of stuff though so I dunno. Also, my boost gauge used to read about -7psi when the key was in the on position before I started the engine, now it reads 0psi before I try to start it. Any ideas on what my problem could be? Any help you cna give me will be greatly appreciated. Thanks in advance, -JP.

[PM-Performance]

why are you messing with the VAFC if you dont really know what your doing ?
see if you can take the plugs out and look at them . might be fouled. but start with the simple stuff first. shine a light into the sparkplug holes see if you see fuel build up in ther if possible. check all your dist and elec connections make sure it isnt something stupid that got unpluged

[Tulo]

What should the compression on each cylinder be?

[PM-Performance]

i dunno . it all depends. post the numbers and ill tell you from there.
if its stock motor youll prob be like 225 or so .