Honda and Acura Car Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
5,517 Posts
if the block has indeed been bored then you cannot use stock pistons. what are the specs on the motor?

it sounds like you just jumped into this project without doing any research on your own leading you to get taken.
 

· Registered
Joined
·
5,517 Posts
see that is what im talking about. you dove headfirst into something you know nothing about when you thought it was a good deal. would you have surgery done by some guy in the backseat of his car because it's cheaper than going to the hospital? i dont think so.

also, the failure to communicate what you wanted to him is evident. he's not a mind reader. you should have been very clear about what you wanted and made sure he and you see eye to eye before any work was started.

take it as a lesson learned the hard way.
 

· Registered
Joined
·
5,517 Posts
i repeat:

Snoopy said:
also, the failure to communicate what you wanted to him is evident. he's not a mind reader. you should have been very clear about what you wanted and made sure he and you see eye to eye before any work was started.
you assumed he knew. you know what assuming does.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top