Honda and Acura Car Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
2,123 Posts
Discussion Starter · #1 ·
Are there any special tools for removing these, I am looking into getting these off of ebay (obx).


Also are the OBX pulleys any good?

Peace:D
 

· Registered
Joined
·
2,123 Posts
Discussion Starter · #3 ·
The brand is cheesy or jus treplacing the pulleys is cheesy. I will be getting this for around 50 bucks shipped. So why not, that's how I am looking at it Bro.


Peace:D
 

· Registered
Joined
·
35 Posts
Lets same its harder then it looks but Regular tools should do it but you may need a impact gun to remove the pulley bolt. Its a pain to take out the alternator pulley because there is hardly any room to take out the alternator. If I knew it was that much trouble I would never gotten it. Especially for no or minimal power gain.
 

· Registered
Joined
·
2,123 Posts
Discussion Starter · #5 ·
see this is the shit I like to hear. Anybody else.......


Also is OBX good quality or not. I feel as though, it's all about the name brand. It's no AEM, but it looks like it will do the job. Anybody else........Opinions please!!!!!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top