Honda and Acura Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
158 Posts
Discussion Starter · #1 ·
I have recently dont my b16 swap but had to cut my downpipe and rotate it a bit in order to mate the exhaust manifold with the catalic converter. Is this how it is supposed to be done or is there an easier better way to do this?
Ive heard of people cutting thier cat to mate them correctly. If so whcih part would you be cutting and welding? Or did I hear wrong?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top