Honda and Acura Car Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
478 Posts
He says complete swap so the tranny is included. I expect you'll need to pick up some half shafts and b series mounts. I know that you'll need the shift linkage bars from a VTEC model. Make sure you get the ECU from him as well when you get it.
 

· Registered
Joined
·
10 Posts
Discussion Starter · #5 ·
ok, well he sold that motor, and ive been looking around and found a d16y8. Will that bolt right into my car? That motor was for the Si model if im not mistaken. So all i would need is to run a wire for the vtec?
 

· Registered
Joined
·
478 Posts
The SI motor will bolt right up. You will need a VTEC wire and the ecu for that motor.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top