Honda and Acura Car Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
610 Posts
Discussion Starter · #1 ·
This spring break, I plan to give my car an overhaul. On my possible to-do list is to bore out the throttle body on my 92 Civic LX. But, I'm wondering is this worth it? Any noticable power gains in daily driving? Does it cost a lot? What diameter should I have it bored out to? I already have a CAI and exhaust. A new header is in my plans for the overhaul as well. Any info would be good. Thanks.
 

· Registered
Joined
·
393 Posts
do you have a d15b7?
if so i would suggest getting a d16z6 throttle body, boring that out and smacking that on your car. a d16z6 intake manifold too.
theyll go hand in hand and give your top-end some boost.
the stock bore is bigger and if you bore that out, itll be even bigger.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top