Honda and Acura Car Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
330 Posts
Discussion Starter · #1 ·
Having trouble with my Passanger side rear suspension. I hit a curb the other night and the back wheel is bent in. I changed the whole rear suspension out. I changed the trailing arms. They are integra trailing arms from a 90-93 integra. something is still rubbing but i dont know what it is. seems like the camber is off or something. the top of the tire is slanted in still. both wheels look almost the same. But only the passanger side rubs. It looks like the wheel is tillting in more on the passanger side []--\\.... if you can picture that as wheels looking at the back of the car lol. Not that slanted though . help please.thanxs
 

·
Registered
Joined
·
330 Posts
Discussion Starter · #3 ·
88ReX said:
when changing out the rear suspension did you also happen to change out the lower control arms from the integra?
So would you use the integra LCA or the crx?
 

·
Registered
Joined
·
330 Posts
Discussion Starter · #5 ·
88ReX said:
Use the crx LCAs if possible. The reason I asked was because the integra LCAs are longer so if you use them then you will have more negative camber due to the LCA pushing the trailing arm out more than a CRX LCA would.
I will check it out. We noticed the top of the roof is bubbled out so i think the frame is messed up form the wreck sux. Had plans for a b20vtec. :(
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top