Honda and Acura Car Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
my friend has a 91 crx si it has the stock engine im not sure which it is d16... anyway he tried to install a new distrubuter himself and now his car wont start it turns over but dosent start. I think he was suppose to mark it and put #1 cylinder on tdc before he did this well he didnt do it.

so know im trying to help him . the car wont even start i think its because the rotor is not at #1 wire and #1 cylinder is not a tdc could this be the reason? if i do this should it start and then just time the engine? any help thanks
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top