Honda and Acura Car Forums banner
1 - 15 of 15 Posts

· Registered
Joined
·
756 Posts
Discussion Starter · #1 ·

this is from the dyno contest at nopi nationals this weekend. i didn't get the chance to tune the cam gears because we only get 3 runs on it. the intake was set to +4 degrees and the exhaust was at -3 degrees.

mods: i/h/e, aem cam gears, and cm 8lb flywheel

i set the cam gears back to 0, 0 and it feels like it pulls better now. got to get it back on the dyno.

for those who are having trouble reading it:

1st run: 145.0 hp, 140.4 ft lb
2nd run: 148.6 hp, 141.8 ft lb
3rd run: 153.4 hp, 144.6 ft lb
 

· Registered
Joined
·
1,507 Posts
from everything that i've read... cam gears are supposed to be set an equal number of degrees off... no?

like +/- 1,2,3,4 degrees? not offset like that? you may make more if they are set equally...
 

· Registered
Joined
·
756 Posts
Discussion Starter · #4 ·
flylwsi said:
from everything that i've read... cam gears are supposed to be set an equal number of degrees off... no?

like +/- 1,2,3,4 degrees? not offset like that? you may make more if they are set equally...
that's not what i was told. i'm going to play around with it until my butt dyno feels satisfied.
 

· Registered
Joined
·
65 Posts
I was there- I saw that run. NICE
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top