Honda and Acura Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
259 Posts
Discussion Starter · #1 ·
FS: BEST OFFER TAKES ANYTHING YOU SEE HERE

Intake mani from a 93 civic
It has been put in a solvent tank and cleaned very good
Intake is striped notthing comes with it, unless you want the fuel rail with it
Looking for around $25 OBO

DPFI intake mani from a 88-91 civic
Has been put in a solvent tank and cleaned very nicely
Intake comes with air temp sensors
The intake has a been ported ported a little bit
Looking for around $15

Rebuilt D15 cylinder head,
Completly taken apart
Hot tanked
Vavles ground
Vavle seats were machined
Valve seals were checked and changed accordingly
Head was decked, to assure no warpage
All gasket surfaces were swirl polished



http://www.we-todd-did-racing....D.jpg




AEM Intake tube. This is a REAL AEM intake tube. This Is a short ram intake for EG-EK civic's. The intake tube has been cut slighly shorter also. It still has the C.A.R.B sticker on it. All you need to do is add a cone filter, and you are set.

BEST OFFER TAKES IT!!!!!




ALSO FOR SALE: GARRETT turbo charger with waste gate. I don't know much about this turbo at all. I have been told that it is from a Detroit Diesel engine. This is in very good shape. There is almost NO shaft play in it at all!!! the only known problem with it is, a small oil leak where the turbo and the waste gate meat. That will be the only seal that needs to be replaced.

$50 OBO!!!!!!!



PLEASE WITH ANY OFFERS PLEASE RELPY TO THIS POST OR EMIAL ME AT ([email protected]) THANKS
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top