Honda and Acura Car Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4,057 Posts
in the gas tank


you need to relieve fuel pressure first.
1. disconnect neg batter connector.
2.remove the fuel filler cap.
3.use a 12mm wrench to loosen banjo bolt from top of filter, hold filter with another wrench.
4.use a towel to soak and fuel that might leak.
5.slowly unscrew bolt on turn. dont forget to replace that washer.
6.retighten bolt

then on to remove fuel pump
1. with battery still disconnected. open fuel fill cap in back of car to relieve tank pressure.
2.remove rear seat. remove access panel.
3.unplug electric control to pump.
4.remove pump mounting bolts and nuts. then remove pump from tank.
5.reverse this procedure to reinstall a new pump.

:tu
 

·
Registered
Joined
·
4,057 Posts
well, this is the integra forum, and the directions and procedures are pretty generic for most hondas. im pretty sure chilton uses most of the same instructions for the integra, TL and RL. and if it dont work for him, tough noogies for not being clear.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top