Honda and Acura Car Forums banner
1 - 3 of 3 Posts

· Premium Member
Joined
·
9,316 Posts
vtecboy said:
hey i was wondering what these two settings should be set at for a standard b16a? cause i am going to initialise the settings and reset everything...........thanks
Leave it alone...When you initialize the VAFC, it sets everything to stock. Just leave all the settings alone. Just be sure that its set to 4cyl, and 6 and 6.

You can take the low-high VTEC down to 5300, but don't touch anything else.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top