Honda and Acura Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hey guys help here
as topic says I got stock B20B internals and a Gsr unported head
no cams or anyhting in yet
Wanna bump up di compression ratio by milling

Wats safer ?
.30 with one layer gasket for about 10.33 - 1 CR
OR
.50 with OEM 3 layer gasket for about 10.42 - 1 CR

I would do the .50 only if yall say its safe
so .... is it safe?
Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top