Honda and Acura Car Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
181 Posts
Discussion Starter · #1 ·
hello, its been a few years since ive been on this forum, but im back into building my lude finally and decided to build a turbo monster. I have my bottom end built and my goal is to get around 600-700hp high boost. I am probably going to use stock cams for now or maybe skunk2 stage 2 turbo cams but im trying to figure a size for the valves. my bore is already over bored to 89mm so i wanted to get oversized valves. Is bigger always better in this application? can I get 1mm oversize without losing a ton of low end?
 

· Registered
Joined
·
181 Posts
Discussion Starter · #3 ·
nope, but it could be on low boost. this motor is pretty bulletproof there is a lot of money into it and its blueprinted. but if anyone has made this kind of power let me know what your head set up is and how it worked, i am able to machine just about anything to get it to work well. do i need to replace valve seats for larger valves if so where can i buy them?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top