Honda and Acura Car Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
I have a question about the MAP sensor on my JDM H22a. I'm installing this swap into a `99 Integra and I was wondering where I should plug the MAP sensor into...can't seem to figure out where it should go. Thanks for any help.
 

· Premium Member
Joined
·
23,755 Posts
one end connects to the ecu and the other to the map sensor...then theres a vacumm hose that comes to the manifold under the mapsensor. on the ecu side the map sensor wires should already be tapped into the 32 prong connector.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top