Honda and Acura Car Forums banner
1 - 1 of 1 Posts

·
Super Ban-Finger Mod
Joined
·
21,366 Posts
http://www.superhonda.com/forum/showthread.php?t=164067
The VTEC oil pressure switch wiring will already exist on the Accord EX’s, but the rest of us need to add the circuit., The plug from the h22a and its light blue wire gets routed to pin D6 on the ecu. The black/red wire form the switch goes to ground.

To hookup the VTEC solenoid, connect its green/yellow to pin A4 on the ECU.
it's very similar to doing a swap into an accord.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top