Honda and Acura Car Forums banner
1 - 8 of 8 Posts

· Registered
Joined
·
665 Posts
Discussion Starter · #1 ·
hey guys, i need your help with injectors. here is my set up

drag gen 3 turbo

motor internals are bone stock

which injectors do i need to pick up?
310cc saturated or 320cc peak and hold

I know stock is 240cc. or do I need a higher rated injector?

thanks for the help
 

· Registered
Joined
·
665 Posts
Discussion Starter · #3 ·
i will be using the greddy exhaust and a hollowed out cat coverter.

msd ignition with blaster 3 coil
magnecor wires
all the stuff that comes with the drag gen 3 turbo kit

I was told i can push 13lbs daily on my stock motor but I am not too sure about that. If i can push 13lbs then i want to push 13lbs but to be safe 10lbs
 

· Registered
Joined
·
320 Posts
You can push generous amounts of boost, but you will need the right parts. I would go for 440cc injectors, a 255lph fuel pump, a v-afc, and colder plugs. Once you have your fuel and ignition setup, get on the dyno and tune the V-AFC. With that, you should be definitely good up to about 12psi I'd say...but you can get away with 1 bar at the track, with some race gas, no probs.
 

· Registered
Joined
·
665 Posts
Discussion Starter · #5 ·
i just read that the honda ecu can only hold up to 310cc
true or false? and some else just told me that the 310cc would be good to push what I want to push and told me that the 320cc would flood the engine a little at idle. stock is only 240cc
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top