Honda and Acura Car Forums banner

How to fit a 3bar map sensor ona b16a2

2K views 5 replies 4 participants last post by  steve1178 
#1 ·
just got one from a place that said it was a kit to install into the b16. All it has got is the plug to wire it up but it wont fit on the Throttle body, seems too big and holes in the wrong place. :bh

Any ideas

Cheers
 
#2 ·
leave the stock map sensor in place, or buy a block off plate for it if you want, run a vacuum line to the new one. Mount it on the firewall, and splice the wires into your stock map sensor. I'm pretty sure that's the jist of it. If any of that is wrong someone chime in.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top