Honda and Acura Car Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter #1
does any one someone that charges CHEAP put is good at what they do to install a turbo..
I have a acura b18a1(95mm crank, Sleeves, Piston 10.1 comp, H beam rods) with a GSR HEAD P&P Skunk Springs,retainers, bigger valves..
 

·
Registered
Joined
·
4,657 Posts
installing a turbo is no harder than an intake, header and exhaust.
Where you located?
 

·
Registered
Joined
·
1,675 Posts
reynosop21 said:
does any one someone that charges CHEAP put is good at what they do to install a turbo..
I have a acura b18a1(95mm crank, Sleeves, Piston 10.1 comp, H beam rods) with a GSR HEAD P&P Skunk Springs,retainers, bigger valves..

slow down a little, lets get complete thoughts out first.
Where are you located?
Do you have the kit or are you piecing it together?
Like itr206 said, it's easy to install.
 

·
Registered
Joined
·
2,245 Posts
dont forget you have to tap into your oil pan.... they sell weldless kits on ebay but i dont know how good they are
 

·
Registered
Joined
·
131 Posts
Discussion Starter #5
itr206 said:
installing a turbo is no harder than an intake, header and exhaust.
Where you located?

I know its easy an all. i just have problem on putting all these bypass valves . I get confused on to what goes with what an all..

im in LA in cali...do you know of any hook up or ppls aroung here that will help me in any way so i could learn?
 
1 - 5 of 5 Posts
Top