[JAYMAN320]

Is it the one on the bottom right...it looks like a rod with a boot at th end of it?

If so you need a ball joint wrench/remover is what you'll needs looks like this:

If you can descrube to me what part or a picture. Ill tell you what tool you need, or if it can be removed

 

[JAYMAN320]

You should be able to take off the boot and "pop" it with the use of a fork wrench...if there is a nut and pin, just take it out and pop it off.

I forgot the procedure on this one...but Im sure you can take it off.

 

[JAYMAN320]

I dont know....it just came naturally to me I guess. If you love what your doing, youll educate and learn everything you can...

Ive learned a lot through my brother and other mech's who I came in contact with. It all started when I was pretty young, around 8-10. I just followed my brother when he used to do engine stuff, and it just rubbed on to me I guess.

wierd stuff ehh??

 

[JAYMAN320]

no it does not just pop out, it actually thresds in. you will need to remove the boot and then loosen it and unthread it. its thats simple.

Its held by a pin and a nut...a fork is needed to pop it out of place.