Honda and Acura Car Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
103 Posts
Discussion Starter #1
Come on SHO people I need to know what the best plugs to use with a MSD
SCI Ignition in an h22a4 all motor setup with the following mods?

PORTFLOW CYLINDER HEAD
DUAL VALVESPRINGS
TITANIUM RETAINERS
NITRIDED VALVES
SKUNK2 STAGE2 CAMS
MSD SCI
BLASTER2 COIL
MSD WIRES
INTAKE/HEADER/EXHAUST
RAN BY HONDATA S100

What heat range? Part#'s

Any info will be greatly appreciated!!!!!!!!!
 

·
On Blakes Nuts
Joined
·
5,057 Posts
ngk is just as good as msd and I like the blue a lot more than red, drop the plans for an ignition your factory is plenty efficient unless you plan to build a 600 hp monster which would cost a lot trust me. Also stock heat range you have no reason to change, I'm running stock range on high compression and it's fine. If you want some advice or tips on an all motor build feel free to shoot me a pm
 

·
Banned
Joined
·
1,898 Posts
he said he already has wires. I went with Denso's. I had oem Densos so i replaced them accordingly. Iridiums that is. I have msd wires too. A replacement ignition would be just a precautionary measure. Not really much of an advanage over stock.
 
1 - 6 of 6 Posts
Top