Honda and Acura Car Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
229 Posts
Discussion Starter #1
Here is the setup that I am looking at. Please let me know what else I need, and give me all of your thoughts.
Skunk2- cam gears, stage II cams, valve springs, valves, retainers, and obd2-1 harness
---rods, flywheel, clutch, Type S pistons, and a port and polish
I am installing all of this stuff on a JDM engine that I purchased, and then I am going to swap engines. I alredy have I/H/E.
Thanks, Dee
 

·
Registered
Joined
·
179 Posts
ssrprelude said:
Here is the setup that I am looking at. Please let me know what else I need, and give me all of your thoughts.
Skunk2- cam gears, stage II cams, valve springs, valves, retainers, and obd2-1 harness
---rods, flywheel, clutch, Type S pistons, and a port and polish
I am installing all of this stuff on a JDM engine that I purchased, and then I am going to swap engines. I alredy have I/H/E.
Thanks, Dee
I'd add a fuel pump, FPR and VAFC to that. And what about a chipped ECU to rev a little higher.
 
1 - 4 of 4 Posts
Top