Honda and Acura Car Forums banner
1 - 13 of 13 Posts

· Registered
Joined
·
1,135 Posts
Discussion Starter · #1 ·
anyone else doin this??
what setup you have??
so far im running :
eagle rods
wiseco 11.5:1 comp. pistons
i/h/e
lookin for some major headwork!
 

· Registered
Joined
·
15 Posts
Gude can do headwork for the ZC claim up to 50 hp.. for just under $1700

they do:

A. BIG BORE THROTTLE BODIE.
B. PORTED INTAKE MANIFOLD
C. PORTED POLISHED HEAD
D. RACEING VALVE GRIND
E. HIGH COMPRESSION RADUIS CHAMBERS
F. CAMSHAFT GRIND TEAM CAM
 

· Registered
Joined
·
1,135 Posts
Discussion Starter · #4 ·
nah... i dont want bullfrog shit im lookin more into a aftermarkwet manifold, ferra valves, larger valves, etc... not just port and polish, gude stuff donsent even coem with stronger valve springs for those high RPM cams
 

· Registered
Joined
·
1,170 Posts
i never liked bullfrog...probably cuz their cams are regrinds. They seems like a cheap company
 

· Registered
Joined
·
185 Posts
squash2001ex said:
Gude can do headwork for the ZC claim up to 50 hp.. for just under $1700

they do:

A. BIG BORE THROTTLE BODIE.
B. PORTED INTAKE MANIFOLD
C. PORTED POLISHED HEAD
D. RACEING VALVE GRIND
E. HIGH COMPRESSION RADUIS CHAMBERS
F. CAMSHAFT GRIND TEAM CAM
:eek: I think that 50hp from just that is nothing more than a claim...
 

· Registered
Joined
·
154 Posts
any one know how to perform a port & polish work
i do have the grinder
 

· Registered
Joined
·
1,170 Posts
w/ a good port n' polish n' big bore TB, agressive cam, complete valve job, beefed up compression n' tuning, it should be possible for you to to pick up close to 30 @ the wheels. But i doubt you'll get 50, even @ the flywheel
 

· Registered
Joined
·
2,120 Posts
i heard crower was suppose to be making a set of cams for the zc that werent regrinds...........?????? i dunno if they are yet to be out.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top