NEEDING A O2 SENSOR EXTENSION OR | Honda and Acura Car Forums

1 - 1 of 1 Posts

DRAGNTHEACCORD

·

Registered

Joined May 30, 2008

·

1 Posts

Discussion Starter • #1 • May 30, 2008

GOT A QUESTION FOR THE MORE EXPERIENCED PEOPLE I GOT A HEADER FOR MY 99 ACCORD BUT THE O2 SENSOR IS ABOUT 1/2 INCH TOO SHORT IS IT OK TO SPLICE IT AND EXTEND IT AND WILL IT WORK OR DO YOU KNOW WHERE I CAN GET A EXTENSION PLUG DC HEADER COMES WITH ONE BUT THEY WONT JUST SELL THE PLUG ANY HELP WOULD BE APPRECIATED

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

91 civic with dc header

Header

I have a 1gen b16 in my 91 si. I have a ceramic dc s port 4-2-1 header I believe. I had a b18a ls swap in 03. Lasted only 6 mo. Then had a 1gen b16. The shop who did the ls installed a dc header. If i ever needed to get another dc header & get a high flow cat what car should i order the header...
- 0
- 2K
- gingas · updated Jun 4, 2013
OBX 4-2-1 Stainless steel header

Header

I bought this header for $60 shipped, and didnt plan to use it long. I, however, still have it, and have taken it off and put the OEM one back on. This thing straight BLOWS. Firstly, it doesnt fit right. It curves under the motor too much, so it aims upward underneath. It should be level to meet...
- 6
- 5K
- SFAL · updated Dec 14, 2009
DC Sports 4-2-1 Ceramic Header

Header

okay, so i had two different models.....one for the accord's stock f23, and another for the h22 i swapped into the accord but had to modify the flanges to fit. for the accord, the fit and finish was awesome. the quality was great and i didn't have any problems w/ the welds cracking or anything...
- 34
- 20K
- UltraMagneticAL · updated Feb 23, 2009
DTR/SSR Header

Header

DTR/SSR B-Series 4-2-1 Header The car 92 Honda Civic CX with a built B series under the hood. Review This header is a beautifull hand crafted piece that produced considerable gains on my motor. The quality and dyno proven numbers of this header ranks it at the top, along with some of the...
- 0
- 6K
- C
  ChicagoMike · updated Nov 23, 2008
Comptech 4-2-1 Header Info

Header

Comptech SOHC 4-2-1 Header Info I just recently got around to installing a Comptech TIG Welded 4-2-1 Stainless Steel Header and collected a little information in the process. The comptech header is a stepped header meaning that each section of piping gets larger. Measurements Primaries ...
- 10
- 23K
- K
  kommon_sense · updated May 22, 2008

Join now to ask and comment!

Top