Honda and Acura Car Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
208 Posts
Discussion Starter · #1 ·
Honda makes three piston sizes for the H23: standard, 0.25 over, and 0.5 over
what unit of measure are they using? would it be translated into the more common .025 and .050 measurements when talking about the overbore?
 

· Registered
Joined
·
106 Posts
skool me here.. If one was to get the .5 overbored pistons and new sleeves what would that make the displacement?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top