Honda and Acura Car Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
419 Posts
Discussion Starter · #1 ·
I am looking at getting some Endyn Roller wave pistons and eagle rods for my zc sohc same as a D16a6 the Bore of them is 75.5mm and Pin diameter is 19.0mm will they fit straight in????

Here is a link to crowers site where it tells you the standard bore size etc

Yes I don't know what the hell I am talking about really but any help would be appreciated.:confused:
 

· Registered
Joined
·
419 Posts
Discussion Starter · #2 ·
Found out the standard bore is 75mm so it will be .5mm, will they still fit or will it have to be machined to fit.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top