Honda and Acura Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,020 Posts
iN cIMA said:
im looking to put a b16a head on a b18b block. the question i have is, if i do this, will there be any needed modifications to the internal parts of the engine? i.e. pistons and rods. are there any other problems that i might run into? Thank you
No internal work is needed. You may run in to oil leak(s) if the VTEC feed line is incorreclty/poorly hooked up. Just make sure its done right and DO NOT half-ass/rig ANYTHING.
Good luck.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top