Honda and Acura Car Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
ia am going to start to rebuild my y8 becasue of a spun bearing, i would like to have it bored out to some degree, im jsut wondeirng how mcuh it can go and wehre ic an get pistons to match it, and where is a good place to get a master rebuild kit, i ahve found a few im just curious which is the best

Jesse
 

·
Registered
Joined
·
11,248 Posts
OEM pistons only come in 0.25/0.010" and 0.50/0.020" oversized. You can get aftermarket pistons in larger sizes if needed. As for parts. I use www.hondapartsdeals.com since I am on the east coast, they are quick. If on the west coast, I would recommend www.slhondaparts.com .
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top