Honda and Acura Car Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
255 Posts
if i was you i'd just grab some of endyn's rollerwaves 9:2:1 and grab a cometic headgasket and bring it around 9ish:1 you should be good to go make sure you hone the cylinders. And use the manufactures specs on pistons to wall clearances.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top