Do you have any engine builders in your area? You should be able to pick some up from them.
using O-rings on stock headgasket?
can it be done? should it be done when you want a good tight seal?
where would you get O rings seals for 84.5mm cylinder bores?
thanks.
where would you get O rings seals for 84.5mm cylinder bores?
thanks.
1 - 3 of 3 Posts
You can do it. Everything will fit and your motor will run fine. BUT, if you are building a motor aggressive enough to need o-rings, then you probably need copper head gaskets as well. Check with SCE, they are very reasonable.
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda and Acura Car Forums
A forum community dedicated to Honda and Acura owners and enthusiasts. Come join the discussion about performance, modifications, concepts, reviews, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
