Honda and Acura Car Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
505 Posts
Discussion Starter #1
Resleaving my h23, what sleaves should i use? What (MM) should they be? I am going to run turbo... so.. can anyone help?
Can i just reuse my new pistons that are already in the engine. or do i have to buy new ones?

Thankx
 

·
Registered
Joined
·
1,208 Posts
Not to be a jerk, but do a search on this site. I'm sure the guys in the prelude or turbo forum can help. If it were me I'd put in Darton sleeves, Eagle rods, and JE 9.5:1 pistons and use a Hondata system to tune the turbo'd car on a dyno. Don't forget to balance and blueprint the whole bottom end. While you're at it if you can Port and Polish the head and do 3 angle valve job would certainly help.
 
1 - 3 of 3 Posts
Top