Honda and Acura Car Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
212 Posts
Discussion Starter · #1 ·
quick Q. i had a shop put my new wheels on but when they did they stripped two studs on each front wheel. they are denying it saying hat they hand torque every nut by hand to 100ftlb but thats bullshitanyways i gotta replace the studs. what do i have to do to swap the studs.i presume i have to pull off the hub. but anything further than that im not sure of.
 

·
Registered
Joined
·
212 Posts
Discussion Starter · #8 ·
once again, it looks like i have to pull the hub. there is not enough room for the stud to come out without it hitting the back plate.i know that most of the time ,yes, you can drift them out.not in this case
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top