Honda and Acura Car Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
yesterday i installed a purge kit and i guess the ZEX computer reseted when i disconnected the power wire. how do i set the TPS again to open on WOT? i dont have the instructions cause it didnt come with the kit when i bought it used. i thought i ran out of gas when i tried to spray cause my car wasnt pulling like it should but then i found out the TPS was reset or something.
 

· Registered
Joined
·
1,002 Posts
turn ignition on but don't start. turn n20 switch on(bottle closed).push button on purple box. light should be red. push gas pedal to floor for 10 seconds. light on box should flash red to green. turn arming switch off then back on. light on box should be green. good to go.
 

· Registered
Joined
·
153 Posts
Discussion Starter · #3 ·
ok thanx. yeah i just figurd it out earlier but that wasnt the problem y it didnt turn on. the wire connecting to the TPS got loose thats y it wouldnt turn on. but i fixed everything.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top